Sun Cooler Information Page

SunCoolers Main Page Contact Information

SunCooler Information and Instructions

FOR QUANTITY ORDER PRICING PLEASE CALL WITH YOUR SELECTION

707-588-9902 8:AM TO 5:PM (PDST)

All phone orders can be made with your or debit/credit card

Instructions for Use

All SunCoolers can be activated for use by soaking the entire item in fresh water for about 8 minutes. (REMOVE WOOD BEAD FIRST)

The enclosed polymer crystals will soften to a gel and inflate to fill the entire sewn in chamber. After about two minutes using your fingers, distribute the gel evenly throughout the chamber.

Remove from water when plump and full but still flexible. Do not over inflate or leave in water unattended as it could cause the chamber to split open possibly damaging the product. Wait 5+ minutes after removing from water or towel dry to avoid possible fabric color transfer.

Use the wood bead on your SunCooler to keep it snug against the side of your neck for best cooling enjoyment. For maximum cooling slide the bead down and half rotate your SunCooler then reset for your personal comfort. Turn them often for extra relief. (About once every 1/2 hour under normal use.)

To keep fresh and clean hand wash frequently. Use dishwashing liquid or any mild soap. Rinse thoroughly.

Reactivate over and over again. A re-submerge anytime will refresh your SunCooler for more continuous all day or all night cooling enjoyment.

Your SunCooler will dry back to its original crystal state in about seven to ten days. For long term storage, keep your (In its crystal state) SunCooler in a dry place. For travel or transport a sealed plastic bag works fine. Do not leave activated SunCoolers sealed up for prolonged periods.

Your SunCooler may be refrigerated or kept in an ice chest (Out of ice melt) for extra cold use, but it is not needed.

FREEZING SUNCOOLERS IS NOT RECOMMENDED